****renewing the add****

------- here's a link to the old adds, including pictures and installations from buyers -------

https://pinside.com/pinball/forum/topic/for-sale-shooter-rod-housing-lighting-kit-new-mod

and

https://pinside.com/pinball/forum/topic/shooter-rod-housing-lighting-kit-new-mod#post-3197831

** as of right now i'm focusing on stern and williams, bally (and housing with sharp corners for williams, bally) **.
all basic colours, red, blue, green, yellow/orange (amber) white are available, still looking for a great purple.
early ss should be available at some point.
mod is plug and play and comes longer screws (1/4 inch longer)
*plunge* (some people are asking for this)*
keep in mind because the housing will be a 1/4 inch away from the cabinet, we need to get that 1/4 inch back to the shooter rod (skill shots), best way is to install a 1/4 rubber inside the shooter tip, included with the mod (some game won't need it), i did the test, my beta testers also and it works fine. (see picture)
or will work perfectly if an aftermarket shooter rod is installed or could be too short.
kit for spike system include a free connector (see picture)
additional splitter/connector are available for $5.
it's definitely a great mod and change the front look of your machine, hope you like it.
thanks, bob.

pellet_in_shooter_tip_(resized).jpg
Spike_adaptor_(resized).jpg

installation:
pretty straight forward, remove the 3 screws holding the shooter housing (no need to remove the shooter rod) and the 2 screws holding the metal plate inside the cabinet, slide the mod in place with the wires facing the cabinet.
pull the wires/plug inside the cabinet, re-install the metal plate and let the wires go down between the 2 screws (doesn't have to be very tight the 3 other screws will do the job).
put the 3 new screws holding the shooter housing.
connect the plug to the 12 volts plug just above the power switch in the front right corner of the machine (maybe you already have a splitter/splitter board) and you are done.
if you have a spike kit use the connector included with the kit and connect to the board in the front left side (see instructions included with the connector).
here's a few pics.

installation_1_(resized).jpg

installation_2_(resized).jpg

installation_3_(resized).jpg

installation_4_(resized).jpg

here's a few pics from recent customs and customers all over the world.
some pics included mustangpaul's leg light ups. here's the link:

https://pinside.com/pinball/forum/topic/new-led-leg-light-ups

WOZ_(resized).jpeg
tron_(resized).jpg
MET_(resized).jpeg
Walking_dead_(resized).jpg
Williams_High_Speed_(resized).jpg
LIne_up1_(resized).jpg
Line_up_2_(resized).jpg

thanks corey, great line up.

got everything in stock for ghostbusters or any other game, red, blue and green.

another nice game. very nice set up. shooter housing and mustangpaul's leg light up.

The_Hobbit_(resized).jpeg

ordering yellow as we speak.
i can put your name on the list.

red, green and blue in stock.

working on yellow.