(Topic ID: 114019)

Shaker motor install in recent Stern (AC/DC)


By PinNerd

6 years ago



Topic Stats

  • 9 posts
  • 5 Pinsiders participating
  • Latest reply 5 months ago by itemkiller
  • Topic is favorited by 4 Pinsiders

You

Linked Games

Topic Gallery

There have been 3 images uploaded to this topic. (View topic image gallery).

motor scheme 1 (resized).jpg
shaker board (resized).jpg
15857926369121792778373502951870 (resized).jpg

You're currently viewing posts by Pinsider PinNerd.
Click here to go back to viewing the entire thread.

#1 6 years ago

Installing a shaker motor in AC/DC, brand new parts. I actually read and followed the instructions--I know, shocking! Powered up, checked the game settings, played a couple games, nada. Completely dead.

Traced back through the wiring, everything looks correct. Proper connectors, no misaligned wires, everything connected tight. Pulled the motor and tested it on a bench supply at 12 VDC, it turns.

Found a meter and tested the supply voltage to the shaker driver board. According to the docs, power on the 7-pin connector should be 16 VAC but I'm seeing 8.3 VAC so that seems way off. Can someone with a shaker installed in a recent Stern verify the voltage across pins 1-7 on J1 of the motor driver board (#520-6803-00).

Many thanks.

#3 6 years ago

This turned out to be caused by a wiring harness error from the factory. It is a simple mistake and was easy to fix. But it should have been caught by the QC process when the harness was assembled. I will post details of the error and fix here in case it can help someone else.

There is a harness that comes with the shaker kit that has a long black/yellow wire to provide ground to the shaker motor driver board. One end of the black/yellow wire connects to the shaker motor driver PCB, the other end connects to J16 on the power/driver board in the backbox.

The backbox end of the harness is inserted in between J16 and the existing wiring playfield harness. The black/yellow wire connects to J16 on the power/driver board to provide a ground signal. The existing playfield harness then plugs into a Z-connector on the shaker harness that connects it back to J16.

When the Z-connector is installed at the wrong end of the harness, the black/yellow wire is not connected to anything so there is no ground reference for the shaker driver. The Z-connector MUST be installed at the end of the jumper cable WITHOUT the black/yellow wire.

Also, once everything was working I checked the supply voltage to the shaker driver board and it is about 10 VAC, not 16 VAC. Everything works so I have to assume that correct.

#4 6 years ago

John_I, my board says Rev B so I thought I had the right part but it is clearly a different part. I will add that board to the list of parts I need and swap it out. Thanks for the help.

Promoted items from the Pinside Marketplace
$ 16.50
Lighting - Led
Lermods
$ 349.95
Lighting - Led
Pin Stadium Pinball Mods
$ 30.00
Playfield - Other
YouBentMyWookie
From: $ 18.00
Apparel - Men
Pinside Shop

You're currently viewing posts by Pinsider PinNerd.
Click here to go back to viewing the entire thread.

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside