Quoted from MagicMako:Voltages from the connector at the DMD
Pin 1 - 120
Pin 2 - 108.1
Pin 6 - 4.8
Pin 7 - 12.1
Pin 8 - 15.2
from what i can understand, the first 2 pins are off by about 4volts? is this right?
1 and 2 need to be 12 volts apart, and they should be negative DC.
Everything looks fine except #8, that should be around 60 v (edit: 62 v).
If you can do board work, buy the gpe kit and rebuild the entire HV section. These boards get very crispy, but you would be surprised how many can be saved.
If you can't do the board work, buy a replacement.