I installed my DBV (accepts $1 & $5) into the MMr and now need help setting up the credit table. It is wired into the connector that is supposed to go to the DBV, not sure what "slot" or "chute" that is.

What I'd like is:

$1 - 1 credit
$2 - 3 credits
$5 - 9 or 10 credits

Thanks

I might go to what you have, but it isn't my first choice. I printed one of those apron cards that has the $1/game $2 for 3 games so that is all I really need. Probably have to test it to see what it does when you slide in a 5 spot.

Thanks for any help. The CGC manual was created circa 1998 when prices were lower ( - :

Figured out this one, use the coin editor. You can do exactly what you need there although the interface is somewhat clunky.

The internal connector for a 12V DBV is the center slot device. I did not need to make any changes to speed up coin acceptance rates.

I put in a 110V MEI 2400 which went in nicely, with 300 bill capacity.