Hi,

Can anyone take a picture J1 Connector on the AS-2518-18 in their Seawitch pinball please?

I'm not sure if i am missing some wires here:

Cheers
J1 (resized).png

Cheers, already looked there - just wanted a picture of one in the 'wild'.

According to the guide the red and white wires are back to front, but on the schematics it says Pin 1 is Red and Pin 8 is White.

J1 (resized).png

So i've re-pinned the connectors on the TA-100 all showing correct voltages. I can't seem to get the 5v on the SDU-100 Rev C.

- Re-pinned connectors J3 and J4
- Rebuilt 5v section (apart from 2.2 Cap)
- New Voltage Regulator (tested on bench)
- Ground mods done and 5v TP1 -> Tp3

Now i can give the board 12v on the bench and all is well, but as soon as i plug it into the backbox no 5v, i've checked pin 12 on J3 and its giving out 12v unreg.

Its got me scratching my head some what..

Any ideas?

Sorted it, the TA-100 was missing a jumper.