I've been upgrading my Scared Stiff (Dancing Boogiemen, ColorDMD) and have a quick question regarding the Spider Wheel.
When I run it in Test Mode the Spider Wheel checks out fine (it will spin forever - counts up to 198 then back to 1 and so on) but in actual play, when a ball drops into the chute and the Wheel spins it spins for 8 revolutions and if you haven't selected anything by then it stops on its own.
I've read online where it should spin for about 35 seconds before stopping on its own. Is this correct, and if so would this most likely be a problem with the Stepper Motor Board/PCB? Any advice or suggestions are most needed and much appreciated!