Judge Dredd
Bally, 1993You're currently viewing posts by Pinsider trolldownstairs.
Click here to go back to viewing the entire thread.
Wpc 89 driver board. Judge Dredd.
Was removing bad transistors when I noticed this resistor looked off. Testing with the meter confirmed it's dead. But I'm a bit confused as to getting a replacement. Williams schematics show R150 as being a .22 ohm resistor. The banding shows it to be a .69. Do the rottendog boards differ from the official schematics?
PXL_20211006_154324015 (resized).jpgQuoted from frobozz:What's wrong with the resistor, other than being gouged up a bit when you were removing the transistor? Merely a flesh wound - I bet it still measures fine.
It measures nothing at all.
Quoted from PinballAir:Failed open?
Also, the solder joints on R150 look a lttle iffy
Looks like it's closed. I get no continuity through it, and measuring resistance just shows OL on the meter.
All the other like resistors show .6 ohms and show continuity.
You're currently viewing posts by Pinsider trolldownstairs.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/rottendog-with-a-rotten-resistor?tu=trolldownstairs and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Salinas, CA