Just picked one up. Haven't even had time to set it up.

20210503_185859 (resized).jpg

A better pic. Needs a cleaning, but it's looking good.

20210504_150952 (resized).jpg

I didn't read through the whole thread yet, but does anyone else have terrible with the ball getting stuck on the y next to the diverter on the left. When the diverter is down, if it's not moving fast enough, it just sits there

20210504_171328 (resized).jpg

Had the middle bumper coil melt and smoke up the machine Friday night. Happened to have a couple of Williams 26-1200 coils, so that was OK. Pulled the board and replaced the transitory with a mosfet. Went through a night of heavy play with no other problems.
It does occasionally hang on the back orbit. Can't see anything that would cause it, so I'm a bit mystified.

Sounds like someone needs to plug in a P-ROC board and write some deeper rules.