Rob Zombie's Spookshow International
Spooky Pinball, 2016You're currently viewing posts by Pinsider blowback1976.
Click here to go back to viewing the entire thread.
Just curious to what people have their Spaulding servo's set to. Mine doesn't seem to be sitting right, and will often cause the ball to get hung up. And when I go into the test menu, if I test the servo to open, it will get to a point where the game just craps out and goes into a reboot cycle and not stop unless power is fully shut off.
Quoted from blowback1976:Just curious to what people have their Spaulding servo's set to. Mine doesn't seem to be sitting right, and will often cause the ball to get hung up. And when I go into the test menu, if I test the servo to open, it will get to a point where the game just craps out and goes into a reboot cycle and not stop unless power is fully shut off.
Figured it out over the weekend.
Quoted from drypaint:What did you figure out and how did you fix?
Previous owner had actually the Spaulding piece pulled off and angled, so it wasn’t sitting on the servo properly. And when it tried to open it would Jam the servo, which would cause the reset.
Pulled Spaulding off and remounted it properly, and it works fine now. No more resets.
You're currently viewing posts by Pinsider blowback1976.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/rob-zombies-spook-show-international?tu=blowback1976 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Philadelphia, PA