Just acquired a rz. Good job spooky running 2.1 no issues
You're currently viewing posts by Pinsider John_in_NC.
Click here to go back to viewing the entire thread.
Followed the procedure loading the beta code from FawzmaGames
and when prompted to restart, I get a bump bump sound repeats every 5 seconds, won’t boot. Can’t get a prompt to try and fall back to 2.1. What can I do?
Quoted from FawzmaGames:That will get you every time
Format the card and recopy
with machine off hold he config_prop button on the main board.. blue button under the spooky ghost fingers (bottom right of ghost)
turn machine on, when (if) you see a count down, let go of the button and let the machine update
IF you can't get it to update via the button, you will need to send the board back into spooky and I'll fix it.
Saw your complete instructions after the fact but I did just that, power off, hold in prop_config, (3rd button from left), power up, once it started programming, let go, followed prompts, good to go. Muchos Gracias
So boys and ghouls, format your SD cards EVERY time you upgrade code. I assumed too much thinking because I had already formatted it and upgraded from 20 to 21, I was good to go, I was not.
Quoted from FawzmaGames:Need to know what you were doing when it happened.
I also hope you aren’t ising eBay//Amazon fuses.
Any changes since 22 Beta? do I need to brick my game again
Will the graphics ever be updated to allow higher resolution? Even at high density dots, it's really rough.
You're currently viewing posts by Pinsider John_in_NC.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/rob-zombies-spook-show-international?tu=John_in_NC and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.