Anyone help me with a switch issues I am having? I believe I just need to adjust the arm on the "Lock Kickout" but I just cannot get it adjusted right.

Shooting in to Bobs Bunker the ball does not come back out. With glass off I can lift the PF a little and it will kick it out. Also with ball in during switch test I can see the same as the below.

Any thoughts?

RS1 (resized).jpg

Yeah been trying too hard to get it bent the right way…

2915B172-2BD3-4379-BB22-C764CD7DB6E3 (resized).jpeg

Hi - I bought a new switch and installed with the same issue and bent it up.

Do you (or anyone) out there know the sequence of events that happen when you get a ball in to Bob's Bunker?

3 Switches Lock 1, Lock 2 (which are on top of eachother) and then kickout.

There is a plastic diverter the ball sits on near Lock switch that must open up to drop to the kickout.

Without a ball locked - what would the above switches do when the ball goes in the hole? Looks like my ball isnt making it to the kickout switch at all.

Thanks!

Thank you - I think I figured it out. I had 2 switches that were not working correctly - I believe that lockup 1 switch activates and allows the ball to drop through the plastic shaft. Then the kickout switch kicks it out. I had to replace my kickout switch and adjust the bottom switch closest to the plastic shaft which I Beleive is lockout 1.

What was throwing me off was having multiple switch issues instead of 1 and not knowing what activated that shaft when the ball goes in the bunker.

If you take a chance on it let us know the quality - I’ve been looking a while can’t find anything worth while