Looks like I’m in the club!!
Just scored a mint RS!
Can’t be happier with the machine.
This is the first machine I’ve brought home, set up, and everything works flawless.
Even NIB have had more issues then this beauty.
It’s going to have a good home for quite some time.
Here’s a few photos.

16C70D02-47CE-4314-87D5-4E9CF73CC3E2 (resized).jpeg

178E8127-C7C0-4512-ABAF-A67572D05FDF (resized).jpeg

2CB963DA-8DB3-4E42-95FB-4E1AAAA11399 (resized).jpeg

70CDBB0A-E11A-48F8-BE93-C5EC7E873BCD (resized).jpeg

F6B6569A-1F23-453E-B766-69A4C472960D (resized).jpeg

@bjsilverballs. Thanks for the great ideas for painting the boom box.
I used some of your ideas, but added a few.
Possibly a little too much “bling”, but fun with my daughter to do something together that we could both work on.

0CCBD941-7422-4DE8-87B1-B4C7ED87184D (resized).jpeg

EC6141D0-4834-424D-9AB1-F2CC5EFF2CB0 (resized).jpeg

Hello all,
I’ve got a new problem with the dozer.
When I start Multiball the dozer does not like to descend. It does go down, just very slowly until it hits the second onto.
In the dozer test mode it works fine. Both switches in front and behind the dozer are working as well.
Has anyone had this problem, and know what I should be looking for?
Thanks for the help.

I just did a switch test and sure enough while touching the wires to the sensor board it went off.
When I pressed on the wires Close to the connector it did not register, but when I touched the wires further up, and very lightly, it registered.
I lightly scuffed up the header pins, re-pressed the wires into the connector, and pressed the copper in the connector to tighten it up.
Works great!! Might have to play 5-10 games After dinner to make sure It’s fixed.
I’ve got a new connector if it starts acting up again.
Happy holidays, and thank you very much for the advice.