I got my LW3 about a month ago and the right slingshot was not working. Turns out the upper leaf switch had one of the tabs broken off and so the wiring to it was no longer connected.
I have a replacement switch in and attempted to solder back into place the wires exactly as they were previously located. Trouble is, I'm not sure they were in the correct place to begin with.
I have attached two pictures, one of the leftside slingshot which works fine and then my rightside slingshot which is not working. This picture is with my replacement upper leaf switch installed. I did get the diode back attached and the little blue highlighted end is towards the middle tab.
I did go through the machine's diagnostics and I can get the slingshot to fire the coil when forcing it to, it just won't fire when you hit the switches with the ball.
Anyone have some pictures they could share or tell me what might be wrong on my own? Only difference I see for sure from left to right is on the right I have a pair of white with blue wires and the left side only has a single white with blue wire in that same spot.