Hello. Spooky is super cool to offer to customers this option. My price is the usual 575 plus shipping to spooky.
If you are not familiar with my process it does take a lot of time, about 12 weeks. I focus on building up a finish that will not wear and dimple like a production finish, and the only way to achieve that is time and elbo grease. It goes like this. I sand the pf including all of the edges of all of the holes and cut outs, I apply 2 coats, allow 15 days to cure, sand everything, including hand sanding all of the edges again... and repeat. after I build 8-10 coats, I allow cure time, and I sand the whole pf level and then up to block sanding by hand to 3000 grit. Then I polish out the surface for usually 5-8 hours. Then I go thru and clean the compound out of all of the cut outs and holes. Before this point, I have sanded and masked and applied 2 coats of poly to the back side to seal moisture and dirt. The high polish will magnify any flaw, and if they or it bothers me, I have to sand it down and do it all again. this happens occasionally.
The way this has been handled so far is people contact spooky and make sure its cool with them. contact me and tell me, and spooky will send me a pf. when it is done, I will contact you to pay me, and then I will ship to spooky. So this makes things real complicated for them, so definitely be cool to them or they will just say no more, and that will suck for everyone. My process takes a long time and it does hold up their production, so it is VERY cool of them to allow this. I would like to think it brings in a couple customers who otherwise wouldn't ,but that may just be ego.
I hope this clears things up.
you can contact me thru pinside or
its better if you go thru firstname.lastname@example.org
As always I would like to thank everyone who makes my job possible, cheers