Here is a RFM a purchased from a router in my area.
CRT to LCD conversion.
A little powder coating.
A few coils.
All new stops, sleeves and springs.
Complete new bumpers. Went with red instead of black. Waiting on red translucent bodies.
All new switches for slings, flippers, bumpers, ball launch.
New flipper bushings, coils, springs, EOS switches, plungers, links.
New NOS plastic set.
All (original) hardware tumbled or powder coated. Including VUK up trough.
Ball launch side rail red enameled.
New green flippers with red gummis.
New "signed by the artist NOS translight" (Thanks Jens!)
All new cointaker super premiums throughout.
Stripped,Treasure Coved, Blitzed.
New "skip ramp".
New martians.

And more crap I can't think of!

Milton

DSCF0286.JPG

DSCF0287.JPG

DSCF0288.JPG

DSCF0289.JPG

DSCF0291.JPG

DSCF0292.JPG

DSCF0300.JPG

DSCF0301.JPG

DSCF0324.JPG

DSCF0332.JPG

DSCF0333.JPG

DSCF0334.JPG

DSCF0335.JPG

DSCF0336.JPG

DSCF0337.JPG

First pic is where I found it on route!

Milty

As we go along;

DSCF0396.JPG

DSCF0397.JPG

DSCF0430.JPG

DSCF0432.JPG

DSCF0435.JPG

DSCF0436.JPG

That piece was broken on my machine too! I did not have both pieces.
Pbr has a partial plastic set on the "special when lit" section. See if the piece is
in that.

<Milton

I also updated the code from 1.0 to 1.6.
Love this machine!

Milton

My LCD was not led. An older Dell 4:3 aspect ratio. 2007 vintage but mint.
I don't even have the LCD tweaked. Looked great right at factory settings.

Milton

I am also creating some custom blades depicting the Martian "war". They should be done next week as well.
I will try to flatten the raised inserts then too.

Milton

I used a Dell UltraSharp 2007FPB 20" LCD Monitor. Used the "Great Lakes Mfg" bracket from Rob.
I cut the power connector off the Wells-Gardener and spliced it on the Dell cord so I use the original power cable.
I did have to router off an 1/8" of the cab to get it to fit perfect.

I have a copy of the "NuCore bootleg" software. But until my Prism card fails I will not infringe on their work!

Good luck!

Milton

Lines up perfectly. I did not have to use the Dell's "picture shift" at all!

Milton

I think a 19" will work just fine! Others have used them.

Milton

Custom blades done and finally installed!
The Pin2K machines are sooo nice to work on.
Easiest blade install ever!

DSCF0469.JPG

DSCF0470.JPG

DSCF0471.JPG

DSCF0474.JPG