Revenge From Mars
Bally, 1999I have an issue with my Flourescent lamp on my rfm. I have replaced the lamp, the starter, and the ballast, but it will not turn on. I have verified 120v ac at the three wire connector between the white and black wire. I have verified continuity between all the wire end points. That leaves me with a bad wire job or fixtures. Any one have any idea?
@ WOLf - yes I did. Every test-able point is good so far. So its either bad wiring or fixtures....
@ nosro - just ordered:
with free shipping. Hope to see in by the weekend.
I just took some 12V led tape and put it on the computer and removed the entire light bracket on mine. Powered it off the computers power supply. Mine did not have the light bracket in it when I got it and I did a Nucore and LCD because my monitor was shot.
I have NUCORE also, but replaced the monitor with an LCD. I had to do surgery on the monitor mount to make it work, but its stable now. That enables me to install the LAMP fisture and since its at the right height, I figure I'll use it. But now it will have to ba an LED lamp instead of a flourescent one.
Now I have a functional CRT with mount an boards - what should I do with it?
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/rfm-flourescent-light-problem and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Hagerstown, MD