Greetings Pinheads,
I'm VERY new to working on pins. I recently got a nice looking Jurassic Park that was dead. It came with no original power supply and the and and a molex, what I think was GI power, that was burnt. two of the wires from the molex had male quick connects on them that were probably used for some jerry rigging. 11903795_10153536447016211_772641087037134841_n.jpg
I replaced the Molex and put the wires with quick connects into their proper connection. I also ordered and installed a new Rottendog Powersupply.
Hooked everything up. Getting Gi lights and garbage on the DMD. No voltage indicators on the main board. I metered the +5VDC from the PS board test points and its at 7VDC! Also metered the 5+V TP on the main board and getting about the same reading or close to it.
I'm assuming thats too high but not sure if its adjustable? Any suggestions are appreciated.