I would dearly like a set for Corvette! Please make that happen
You're currently viewing posts by Pinsider allsportdvd.
Click here to go back to viewing the entire thread.
Quoted from allsportdvd:I would dearly like a set for Corvette! Please make that happen
No love for Corvette???
Quoted from Aflacjack:My decals are pretty bad, but the backbox ones are trash. Being that I have changed essentially everything except that, I figure it will be a big improvement. I just got a forstner bit set, but kinda leery about the hole drilling. I dont wanna jack it up. Are there instructions included, or best practices?
I'd like to know this too, no instructions in my box. Was going to use regular drill bits and then cut the rest with a stanley knife like I would regular decals, especially seeing the bolt holes are square
Quoted from Kerry_Richard:Re: cutting holes for flipper buttons, start buttons etc on the Rad Cals.
EZPZ, Crisp, Quick and Clean. Simply drill a small pilot hole and drop this Flush Cut router bit in. Clean flush cuts in seconds!
I use the smallest flush cut ball bearing I could find on the Net. Amana Tool MR0105 Miniature 3/16 D Flush Trim with 3/16 D Ball Bearing x 7/16 CH x 1/8 Inch SHK Carbide Tipped Router Bit
https://www.toolstoday.com/v-12109-mr0105.html?glCountry=US&glCurrency=USD&ne_ppc_id=1701009076&gclid=EAIaIQobChMIjJWbvs7u7QIVyhOtBh0OOQe9EAQYASABEgIDBvD_BwE
I also purchased this for my Dremel. It works beautifully. I showed my 2 buddies and they used the one that came with their Dremel with similar results.
https://www.stewmac.com/luthier-tools-and-supplies/types-of-tools/routers-and-bits/routers/precision-router-base/?lac_guid=1d39d0ff-2c49-eb11-8102-ecb1d775572b&utm_campaign=EMAIL-ORD&utm_medium=Email&utm_source=Order_Confirmation
Hope this is helpful
Kerry
Now I just have to find the Australian versions, thanks for the help!
Quoted from Aflacjack:Shipping delays suck. Been a month since my order and crickets.
Same here
You're currently viewing posts by Pinsider allsportdvd.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/revised-rad-cals-for-many-more-wms-games?tu=allsportdvd and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.