Highlands Ranch, CO
in for 1. less than $100 would be fantastic.
(Topic ID: 69887)
You're currently viewing posts by Pinsider Anim8ormatt.
Click here to go back to viewing the entire thread.
Quoted from kray37:Ok the spinout ramp is, and only can be done by an injection molding tool(as original was formed)! Someone has that tool, whomever bought parts from Illinois Pinball. It cannot be done by vacuum thermoform.
hopefully it's not a boat anchor somewhere. i bet it's a large mold.
Quoted from kray37:I spoke with Gene personally and he only has one side of the injection molding, not the other, so that shoots that out of the water! He said he might have the spinout ramp though and told him he ought to remake those if he can find that tool! He's going to check on it.
that could take YEARS. His warehouse collection is gigantic.
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider Anim8ormatt.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
