I am new to pins and my Addams family needs a little TLC. It’s going to need new rubbers and in looking at the playfield seems there are a lot of tricky spots, almost to the point were I will have to remove entire ramps.
My question is - what is the best way to go about this? Specifically when there is switch wiring attached to the ramp that needs to move to get the rubber installed.
Do I just go slowly lifting pieces one at a time taking extreme care at the solder points of the switch? Or is there another approach I am missing? My fear is moving these ramps (specifically the metal rail return ramp) without messing with the switch connectivity.
Any advice is appreciated.