Post #13 This post describes Williams games. Where to solder which wire of the new cord, why you should replace the 8 amp fuse with a 4 amp fuse (or smaller), the purpose of a MOV, and finally why the service outlet is unfused. Posted by vid1900 (9 years ago)

Post #15 This post describes Vid's procedure for replacing the cord on an old EM game that had only a two prong cord when it was new from the factory. He also discusses adding ground braid to the game. Posted by vid1900 (9 years ago)

Post #16 This post describes how to test a wall outlet for proper wiring. Posted by vid1900 (9 years ago)

Post #17 This post answers the common question 'how many games on one breaker'? Posted by vid1900 (9 years ago)

Post #18 This post offers a solution if your wall receptacle is wired incorrectly and you're unable to run new wire all the way back to the breaker box to fix it. Posted by vid1900 (9 years ago)

Post #19 This post describes how to test your re-import WPC game for incorrect wiring. Posted by vid1900 (9 years ago)

Post #30 This post describes how to correctly wire a service outlet inside your game. Posted by vid1900 (9 years ago)

Post #43 This post answers a reader's question about using an adapter. Vid says why it's not a solution and describes the correct way to fix it. Posted by vid1900 (9 years ago)

Post #53 This is more discussion on re-importing a game and the necessary wiring changes. Also more great information on replacing the MOV. Posted by vid1900 (9 years ago)

Post #55 More great MOV information. Posted by vid1900 (9 years ago)

Post #78 This post shows what properly prepared wires in Germany look like. They use wire end ferrules. Posted by german-pinball (9 years ago)

Post #82 Great post about adding a MOV to games that don't have one. Posted by german-pinball (7 years ago)