I have a Bally Strikes n Spares where someone before me had put an after market chute launch on it. The handle has come off and while I could re attach it using the lock pin (I think it just slid off over time) I might investigate putting an original looking launch in there.
Photos are attached.
Can anyone advise of an original looking part which fit this machine? Depending on cost I’ll see if I attempt to re attach (am concerned with it coming off again though!) or buy a new one.
I’m in Melbourne, Australia so that may make it tricky to source a part too
71895291-ABE0-451E-8208-784000A4936B (resized).jpegFAD73634-4142-4DE2-A87D-41A653CB1178 (resized).jpeg2C4FAB1E-74C0-443F-BEC0-A92C30E4A2FF (resized).jpeg