Is there and recommendation on redoing the smaller idc connectors with molex of the bally wpm boards...Ive repinned/new connectors on the bigger pins before but have never the smaller ones... looking for size recommendation, pin types, any improvement suggestions
Ed at Great Plains Electronics is selling out of his inventory but I use this crimper
https://www.greatplainselectronics.com/proddetail.asp?prod=W-HT-1921
and the connectors you need are this:
https://www.greatplainselectronics.com/proddetail.asp?prod=08-50-0114-C
I use the old connector housings, but here is his listing for the housings and the pins:
https://www.greatplainselectronics.com/categories.asp?cat=70
Quoted from PinRetail:Ed at Great Plains Electronics is selling out of his inventory but I use this crimper
https://www.greatplainselectronics.com/proddetail.asp?prod=W-HT-1921
and the connectors you need are this:
https://www.greatplainselectronics.com/proddetail.asp?prod=08-50-0114-C
I use the old connector housings, but here is his listing for the housings and the pins:
https://www.greatplainselectronics.com/categories.asp?cat=70
I used to use that crimper, it’s single stage, this one is dual stage, much better.
Dupont Crimping Tool for AWG24-16 (0.25-1.5mm²), Flytuo SN58B Terminal Crimping Tool and Wire Crimper works for Dupont Wire EPS,SATA,PINS MOLEX,JST Terminals https://a.co/d/gAtUzps
Quoted from Lermods:I used to use that crimper, it’s single stage, this one is dual stage, much better.
Oooh nice!
Order placed!
Thanks!
I’ve repin the bigger pins before and have a nice ratchet crimper, just never have repinned the smaller pins and wanted to see recommendations before purchasing.
I’ve got a few wire that keep coming out of the idc connectors and just wanna redo them right.. Thanks for all the suggestions!!
Quoted from rockwell:I can help you out with crimps if you need...
https://wirebot.xyz/products/0-100-crimp-contact
Thanks for providing this! Will be ordering soon. Any pinball pre 1983 should be repinned.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/repinning-connectors and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Louisville, KY