Blackout
Williams, 1980You're currently viewing posts by Pinsider maddog14.
Click here to go back to viewing the entire thread.
Presented non working, dirty machine : How many hours do you think it would take to do some minor board diagnostics and repair, removing and soldering in a relay and a few transistors, a resistor on display board, tear down, clean, wax , install leds and color match. a refurbish on flippers and related coils, Ultrasonic clean removed parts, put it all back together, adjust where needed etc.
5 hours? 10? 15?
I am about 13.5 hours into doing everything. I had to repair a lot of crap on the boards... And The owner just got the boards back from a guy in chicagoland area too.. This guy installed the remote battery pack........Wait for it..... Right back on the board to potentially leak acid again. That is the last thing I have to do is redo the battery pack.
I just wanted to compare my time to see if I suck or not time wise. It sounds like I am right in the mix for what it should take.
Thanks for all that took the time to comment and take the poll.
You're currently viewing posts by Pinsider maddog14.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/repair-and-shop-out-time-estimate-for-blackout?tu=maddog14 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Berkeley Springs, WV