Just did this with SW Pro this weekend (EHOH, TWD LE, and Rolling Stones LE are in line for theirs) it is much easier if you have an extra set of hands to help...Just a few connectors (If you are unsure make sure you mark the connectors before disconnecting them so you know what goes where), there also might be a couple cable ties that need cut (I think I cut 2) at the back of the PF/cab to disconnect then carefully place your hands on the sides (without squishing the ramps you can place your hands between the ramp and the PF just don't grab it without paying attention to what you are grabbing) lift the PF up and out. When you have it out you do need to sit it on the apron side as there are lights and things on the backboard end that you don't want to squash but not to difficult. When placing the PF back into the cab. I laid some towels over the newly installed side art to protect it in case of a slip while replacing it! Don't want to scratch the new side art.
Phoebe