We were very busy the last 3 days. Unfortunitly we cant print every day.
The last days I spend sanding playfields for the paint shop will open on Monday again, dont want them to run out of work.
Leon was busy programming and milling.
The video is showing sanding different playfields, still not finished with sanding but have a huge pile and the milling at the end.
Today we started to catch up a bit, we printed 2 colors, the Ocra and Yellow.IMG_0086 (resized).JPGIMG_0092 (resized).JPGIMG_0094 (resized).JPG
All work out quiet well, the yelow gets printed over the dark blue, it was quiet a tackle for it turns out into olive green, the trees and the poles for the signs. It was important to get as close as posiible to the dark blue original shade and then adjust the yellow to achive the olive green, a bit to blue or to yellow and you wont get the olive green.
The same with the ocra, if you look in the middle of the playfield you will notice that the ocra is getting darker at the top, at the bottom of the ocra is dotted flow of dark blue, you will notice if you look at the dark blue print. This will make the efect in the later printed green, you print one green shade but achice 2, one with a color flow. So far all worked out well, lets hope we hit the right shade to get the correct effect.
6 colors are now printed, 6 colors still to go. Tomorrow we will print the next 2 colors, orange and red. If we feel to we will then print the next 2 colors on Sunday, hope the weather is bad
Have a nice evening
Leon and Peter