I'd replace the 100V zeners in the display section with 92V ones whilst you're at it. There was also a WMS service bulletin that said change R2 and R5 from 680ohm to 1k2 ohm 1/2 W and it's suggested to upgrade R1 and R4 to 39k ohm 2W.
You're currently viewing posts by Pinsider SYS6.
Click here to go back to viewing the entire thread.
You're currently viewing posts by Pinsider SYS6.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/rebuilding-power-board-williams-system-3?tu=SYS6 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.