Hello all,

Please forgive me for continuing to exhibit my complete noobiness, yet I would like to install the ball eject Cliffy protector on my STLE but I do not exactly see how the apron comes off. I see the screws on the back of the apron (which attach to the metal latches) but what else is holding it down?

Thanks all!

I see. So just the two metal screws on the back of the apron then? I will give it a better push once the two screws attaching it to the metal brackets are out.

Perhaps the apron is like my lock down bar: very tightly attached! Well, at least nothing will fall off my LE!

Thank you!

Sounds good, thank! I just was not sure of the two screws in the back (attaching to the metal latches/brackets) were the only ones.

Excellent. It just looks like my set-up was tight again, which is fine I suppose.

Thanks again!

Thank you! I have not had a chance to try again, but I will look for these!

Thanks again!

Lol! No worries at all! It will all work out!