My +12VDC is measuring around +5VDC (don't be confused by the coincidence that it is around 5V).
Here is what I've measured:
AC input voltage (pins 10/11) is supposed to be 18VAC. I measured about 20VAC.
I also measured the BR using the diode setting on my DMM, and all good.
Voltage across C1, -12VDC, as it should be.
Voltage across C11-C14, +5VDC. It should be +12VDC.
Capacitance across C1, 1000uf, as it should be.
Capacitance acress C11-C14, 19000uf, as it should be.
AC voltage across C11-C14, 0VAC, as it should be.
Resistance across C1, 6M ohm - I suspect that's correct.
Resistance across C11-C14, 6M ohm - I suspect that's correct.
I measured the capacitance and resistance with power off.
I measured the voltage with power supplied, obviously. I removed all connectors, so there would be no load.
I am a bit confused on how this can produce the wrong voltage, given what I have measured.
This is a REALLY simple circuit for