I picked up a PF that was partially torn apart and am trying to get it back together. I need the upper left ball gate which I can get from Marco if nec. The cover for the ball diverter at the back of the pf to keep the wiring out of the mech is missing, I can possibly make up something for that if needed. I also need the three hex spacers that mount the center ramp that I have circled (see pic) if anybody has part numbers or can tell me the size of these that would work also. Thanks, Mike

IMG_6575 (resized).jpg

Bump. Can anybody get me the length of those 3 hex posts? Thanks, Mike

Not for those posts.

Thanks. The Williams manuals of this era seem kind of hit and miss with what is in them. Police Force only has a list of rubber rings, no chart and only a few of the ramp posts are listed. The Pinbot manual is short on a bunch of info also. You are correct I need someone to measure their's. If I get to the point, I'll have to mount the ramp and see what might work.

Yes you're correct, I have the taller one. Is that the measurement on all 3 I have circled in the pic? I'm sure the .007 is tolerance. Thanks this helps alot.

Actually paying attention now the difference is .07 that is probably more deliberate. But if nothing else I can cut the 1.875 post down to make it work. Thanks, this helps alot.

Parts are ordered. Thanks for the help. Here's what they had in place of the spacer and the pf post in one spot.
20220720_194637 (resized).jpg