Paksoi
You need a torx T-20 bit.
On mine you can access the bulbs by opening the back box and
Reaching up through the access holes.
Hope this helps
Jim
You're currently viewing posts by Pinsider liftserv.
Click here to go back to viewing the entire thread.
Paksoi
You need a torx T-20 bit.
On mine you can access the bulbs by opening the back box and
Reaching up through the access holes.
Hope this helps
Jim
Quoted from SilverUnicorn:Ok, so…..this damn diverter!!!! The coil was crispy when I got the dame and the diverter was all gummed up. Replaced the coil and cleaned up the assembly.
Still nothing. Replace the TIP and associated prescriber and nothing. Thought I may have other board issues.
Installed a replacement System 11 board (new, from Dimbass). STILL nothing from the diverter.
Not sure where to go next. It does NOT fore in coil test. Wiring is secure as far as I can tell.
Any ideas?
Also. Does this plug look correct? This is from the relay near the diverter.[quoted image][quoted image][quoted image]
Hi Chris
My cab is the same as yours, I can’t remember for sure, but I think ours are the early cabs?
Also if you still need a pic of the connector let me know. I’ll be home Tomorrow and I can take a pic.
Jim
Quoted from JMacTX:I actually ended up making own repair pieces that are very similar to the ramp protectors. Just some sheet metal and some careful fabrication. Will do for now, as it’s going to be an exclusive home use machine. [quoted image][quoted image][quoted image]
Looks great!
You're currently viewing posts by Pinsider liftserv.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/police-force-club-we-enforce-the-law-of-the-jungle?tu=liftserv and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.