I just picked up a Police Force, missing the topper. Anyone tried 3d printing replacement toppers for them?

New to the club, I have a Police Force missing the topper, anyone have one? PM me if you are willing to part with one and willing to ship if not near me.

Thank you

Can anyone take a picture of the light board behind the jail, mine is just laying down held up by the ramp and the wires, and am looking for a better idea of how it is supposed to be.
Thanks

So my machine sat in a garage for 12 years. So far I have fixed 3 switch errors, put new molexes on the interconnect board, GI as usual was burnt. I have replaced the rusted up legs, soldered on about 2 loose wires on the coin door, started to replace the bulbs with LEDs, I found the blue beacons for the topper and the light boards that go underneath, and have got the car running, it apparently had been broken long before it went to the garage for storage. I also got the flippers working, a fuse plus a loose wire. The list is far from done, but at least I am making progress on bringing this one back.

I also have the C and E on the lamp board not lighting underneath the playfield, might pull the board when I get a chance. And I have the famous diverter error, seems to be a regular thing, one of these days i will pull the playfield and get it fixed.

20210411_082916 (resized).jpg

Well I replaced the diagnostics switch in my machine. Finally I can get through test mode, the old switch i had to mash repeatedly to get through one step.

Also, feel free to make fun of my soldering, I just started soldering with this machine, I described this job akin to a 12 year old boy giving it a go.

20210327_173226 (resized).jpg

20210417_073613 (resized).jpg

20210417_073712 (resized).jpg

20210417_073816 (resized).jpg

Thank you! I will certainly redo it, I appreciate the advice.