Boulder, CO
What's the Tilt Hold (H) relay doing?
(Topic ID: 214478)
Linked Games
Target Alpha
Gottlieb, 1976
Topic Gallery
You're currently viewing posts by Pinsider howardr.
Click here to go back to viewing the entire thread.
Quoted from jaybird5619:Score reels reset and then immediately the thousands reel starts up. Score motor runs continuously
If the 1000 Point relay is pulsing, narrow down on the problem by putting slips of paper in the various circuits that can drive it.
Quoted from HowardR:If the 1000 Point relay is pulsing, narrow down on the problem by putting slips of paper in the various circuits that can drive it.
Quoted from jaybird5619:HowardR -- resistance between White/Orange lug on D and any of the upper rollover switches is .06-.07 ohms. On the drop targets, I did not get any reading (other than the DMM default reading of "1" (with DMM set to 200 ohm). Maybe I'm doing something wrong? Also, wires on my machine are very faded -- I'm assuming the yellowish wire feeding the end of each drop target bank is the yellow/maroon. Blue/Black was very clear.
Quoted from jaybird5619:It's the 100s reel (not 1,000s) that's acting up.
If the 100 Point relay is pulsing, narrow down on the problem by putting slips of paper in the various circuits that can drive it.
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider howardr.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
