I did a pro but it will be very similar. You basically have to remove all the plastics on the lower PF as well as the ramps, flippers, and any spinners or gates. This isn't too much. The ramps will have wires from lights and switches attached to the bottom of the playfield that are connected with molex Z connectors. I like to label each side of the connector with a number before I disconnect it so there is no doubt which connector goes where. Fishing them through the playfield on reinstallation can be the tricky part. All in all, it's not too tough a process just time consuming. Don't forget to clean your playfield with naptha before installing to remove any wax.