I'm replacing a busted EOS switch on the right flipper, but there is inconsistency between this and how the EOS on the left flipper is wired to the coil. On the existing blown EOS, the wire from the longer blade leads to the middle position on the coil housing, and the shorter blades to the right side of the coil looking from the back. This is opposite of the left flipper, where the shorter blades on the EOS are wired to the middle position. Am I thinking about this too much and just replace as wired? I couldn't derive much from the schematic diagram. Newbie here, in case you've gotten this far and haven't easily figured that out yet Thanks!

Flipper probs (resized).jpg

Great, thank you!