If Someone could please post a photo of their power board but not zoomed in
I have an orange wire that is not connected anywhere.. it’s paired with a black wire
Thanks
You're currently viewing posts by Pinsider topkat.
Click here to go back to viewing the entire thread.
If Someone could please post a photo of their power board but not zoomed in
I have an orange wire that is not connected anywhere.. it’s paired with a black wire
Thanks
Quoted from PM_Jeremy:Photo attached[quoted image]
Thank you!
it looks like they head upper right which Marvin mentioned is the knocker...thanks again
Quoted from PM_Jeremy:Those may be 24v bulbs. So choose wisely
What is safest for those as far as led ? Or better to leave as is
Does anyone know what post that is in the picture that I am missing I went through the manual and swear they don’t label that post. The one I ordered is too large a screw for that space ?
If someone has extra I’d buy it even used
Thanks
Quoted from Plumonium:May be check other suppliers.
Found one somewhere else. Bought a few to try to justify shipping
Thanks
Quoted from PantherCityPins:Hah, got lucky and found a wire ramp locally from a used arcade parts store, whew! I was afraid I was stuck.
Still need to figure out what that post is, is it the same as the upper post on the same (left side)? Looks like a post with a double female hex spacer and then a metal mini post?
This is it I believe
image (resized).jpgQuoted from Plumonium:I have this setup for the post you are looking for.
[quoted image]
[quoted image]
strange..so mine had a different one it appears
has anyone put the Cliffy's on their pinbot? looks like it protects the raise/lower target pretty well..
Quoted from Plumonium:Make sure you have this piece and adjust the screws underneath on each side. Mine was missing the bracket and I had to chase it down.
As a side note, a previous owner also glued a shim on top of the target bank to level it off...
[quoted image]
thankyou!
I do have that bracket..will take a look
When reinstalling the visor is there a trick to get it to sit down properly When I hooked mine up and power up it doesn’t rest in the down position.
Rods aren’t bent and bushing is there
I will take a photo.
Unfortunately I have plenty of time to get his figured
Ok got it all together. Visor sits properly.
I was test plying it and the only
Complaint is the upper left saucer( the one to the left of the visor ) is a tuff shot. It bounces at some of the time. Is that a tuff shot or do I need a cushion on the deflector
Quoted from FLASHBALL:I have the same problem on my Taxi with the Jackpot/Gorbie shot. Annoying when I drill the Jackpot and it doesnt count. I've thought about putting a thin rubber pad for cabinet doors on the deflector. Not sure though.
Do you thin the deflector need to be bent forward or is It the angle.
You're currently viewing posts by Pinsider topkat.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/pinbot-fans-and-owners-club?tu=topkat and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.