Pinbot
Williams, 1986You're currently viewing posts by Pinsider tavsplace.
Click here to go back to viewing the entire thread.
I need to replace the ribbon cables for the displays, looks to be five of them. I have searched for replacements but I have not found anyone that has them listed specifically for Pinbot. Anyone know what part numbers I need to order? Or will I need to measure and count the pins on each cable? Any help is appreciated.
Putting back together the vortex area and there is a short ball guide behind the vortex ramp area, it appears its been moved a few times by the screw holes. Question is it supposed to be there? If so trying to figure out if it just sits behind the side flap or somehow slides behind the side flap? Let me know if you have any ideas. Thanks.
002A938F-800E-4E3E-A379-7442D1E4C1F3 (resized).jpeg34B6C65D-A141-45DD-B8F1-D721CC8E0F8C (resized).jpegA2A2A9A0-7DD7-4EBA-8B38-F60A39AC0787 (resized).jpegQuoted from WeirPinball:Mine didn't have one, looks like it was put there to support the entrance.
Thanks!
Quoted from Vin-bot:TAVsPlace , it’s not on mine either, but it looks like the guide used is same as the guide at the advance planet (green) target
Cool, appreciate the feedback.
Quoted from vec-tor:Here, from Jackbot, has the amendment.
Item #16
Any chance of getting a close up pic of the actual game with this? I too have been banging my head against the wall over this issue. Thanks!
Quoted from floyd1977:I ordered the wireform referenced and it is curved. It looks straight in the pics linked above.
I noticed the same thing, I ordered two just to have an extra. I have not installed yet as I was not sure it was correct.
I forgot to take a pic before I put everything back together but used a 3” wire guide and bent it a bit, works good, not 100% but a lot better than it was as far as hitting the vortex. I think I would use a 3.5” but all in all it’s much better. Still some tweaking to do but getting closer that that almost perfect plunge.
F1A67F0D-0371-4CAE-BDA4-0D349473FC53 (resized).jpegYou're currently viewing posts by Pinsider tavsplace.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/pinbot-fans-and-owners-club?tu=tavsplace and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Clovis, CA