(Topic ID: 224957)
You're currently viewing posts by Pinsider angryarty.
Click here to go back to viewing the entire thread.
Portland, OR
I saw that thread, but what's throwing me off is that the *current* configuration isn't listed in the manual.
I'm getting the impression that the pin labeling floating around the forums is not applicable.. pins 10 and 11 HAVE to be connected to something to get 240V or 220V.
Yep, after closer inspection, it was my orientation that was incorrect. Rotating the molex connector corresponds to the 240V config. See the pictures below. Hopefully this will help someone else that was confused!
Untitled (resized).pngvoltage (resized).jpg 3 months later
Also, it should be noted that the ballast for the fluorescent light should be replaced when doing a power conversion. The 50Hz European ballast is not compatible with the 60Hz electrical system. Order a 60Hz ballast that works with F15T8 bulbs. And if you need to replace the starter, grab a FS-2 from your nearest Home Depot or Lowes.
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider angryarty.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
