Volcano
Gottlieb, 1981What do you do if you need to repin a Gottlieb double-sided edge connector. I ordered a kit for the MPU to solenoid driver board but I have one more of these connectors on the bottom of the solenoid board I'd like to repin as well. Will the Molex 08-50-0116 do the job?
Molex 08-50-0116
SOCKET 18-20AWG BULK TIN
08-50-0116 (resized).pngThat one will work on single sided connectors, which two of the three connectors on the bottom of the driver board are.
08-50-0108 will also work, and is stocked by www.greatplainselectronics.com
--
Chris Hibler - CARGPB #31
http://ChrisHiblerPinball.com/contact
http://www.PinWiki.com - The Place to go for Pinball Repair Info
With system 80, I don't repin the edge connectors unless I suspect a problem. Pretty much the only thing I do is clean off all the edge connectors with a pink rubber eraser and repin the power supply connectors when I rebuild the power supply.
For the double edge connector, these were the pins, but they are NLA: https://www.greatplainselectronics.com/proddetail.asp?prod=08-03-0304
Docent electronics make a replacement harness, or you can try looking for a 24-pin dual-sided card edge connector and make your own.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/pin-replacements-for-gottlieb-double-sided-edge-connectors and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Birmingham, AL