Working on my Phantom. My upper GI lights on the backbox are dead and I traced it to a blown F3 fuse. Putting a new one in and of course it blew right away. Any tips?

Also anyone know how the large capacitor should be wired?

Thanks POTO team!

AFBB9D9B-718E-40F4-A90B-75E35943A002 (resized).jpeg

B2F85375-C3B3-4BDE-83EE-7F9FC1ECAF3E (resized).jpeg

Thanks!

What is the leg length for the Phantom from the factory? Mine has 28.5 and 31 rear? It does not seem correct?

I am going to try swapping a 28.5” in the rear. Manual says 6deg incline. At the moment my 30.5 in the rear have no give to change.

Attacked the mask decal install. Lots of arts and crafts to cut out the mask but it was not that difficult in the end. It does have transparency so the flashers do show the face behind the mask. A+

2BB39A51-DD84-47FE-BE87-3CEE49C9D3B1 (resized).jpeg

77E34F9B-7B5F-4194-B758-BF3631FAA567 (resized).jpeg

0461E31F-787F-43A7-9292-7F9BDC47C594 (resized).jpeg

79F474CE-E6C9-45B2-9ED3-1B679EECAACB (resized).jpeg

Mine had no mask at all! The top of His hat is still gone but no decal that far up to replace.

Anybody have a shot of the spinner on the right upper? Mine does not spin at all and it sometimes stays 1/2 way open. I believe it’s the link down to the switch binding but now sure. Mine needs a tear down and this week.

Thanks

I placed a white party table next to mine and lifted it out. Have someone help you lift it and place it on the table. I did not disconnect any wires. When done you will need a hand placing it back in.

E8CBE7D9-85B2-4CAF-AEAC-15DB39CD7DF6 (resized).jpeg

Anyone rebuild the VUK on the right side? Seems like mine is sticking a bit when it goes in the center to the right side. It does not seat back to original position so the ball goes down the tunnel and rests next to the white plastic VUK. Bang on the cabinet and it seats down so the ball will roll on top of it and continue game play. Started taking it out but not sure how to break it down to clean and re-sleeve the coil. Has a snap ring and u shaped switch. Anyone been down this road before?

Anyone interested in retro Refurbs cabinet wrap set for POTO? Decided not to go that route, PM if interested.