Hi Buddy,so those are not working during gameplay?When testing those solenoids in test menus is the coin door closed?theses a hi power shut off knob on the left side near the coin door.
You're currently viewing posts by Pinsider pinmike.
Click here to go back to viewing the entire thread.
Hi Buddy,so those are not working during gameplay?When testing those solenoids in test menus is the coin door closed?theses a hi power shut off knob on the left side near the coin door.
Quoted from Jmckune:Maybe cold solder joint at coil? This could cause intermittent issues if it were jostled just right/wrong. Try reflowing solder at the coil?
Could also be cold solder male header pins on the board.On the chart both coils are low power and the connector on the board is
J-127 according to the chart.Try reseating that connector on the driver board.
Quoted from crujones4life:True...but it would be unusual for both coils to have cold solder joints develop at the same time...unless they are wired in series and one is causing problems with the other? I will look into that. Thanks.
Check connector J-127 on driver board first
Quoted from crujones4life:Tried resetting the connector. No luck. Could be cold solder joints on those 2 pins but that would also be unusual for both the develop at the same time. Something to look into though. Thanks.
In the pin hobby anything is possible
Quoted from crujones4life:Maybe I have a break in a wire?
Check continuity from the connector to the wires going to the coils
You're currently viewing posts by Pinsider pinmike.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/party-zone-outhole-and-ball-release-help-please?tu=pinmike and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.