After playing a couple games on my newly finished Paragon, the inline drop targets are falling about a 1/4" below the PF causing the ball to get stuck there. It appears the lower plate on the drop target assembly sits an equal amount too low causing the reset bar to lower the targets too far. Since there isn't any adjustment to this bottom plate, is it possible that is from a different game with different length drop targets? I went thru 2 PF's / multiple parts piecing this game together. Can anyone with a Paragon look at theirs and see it the lower plate is flush to the side plates?

DSCN5809 (resized).JPG

DSCN5811 (resized).JPG

Thanks! I must of failed to install that bracket when replacing the drop targets.