Joined the club finally

IMG_0070 (resized).JPG

Yes loaded with everything I wanted.

New to the club and having trouble with outlane drains from the right ramp drop where it just goes up and out. Without reading all the posts hope someone can recommend something. I tried shifting the ramp angle with no success. I don't have the machine in its final spot nor leveled so may be the issue.

Ya I will when I move it into slot. Other thought is to deaden the ramp end, maybe needs a new grommet.

I should clarify, I hit the left ramp clean and the ball drop on the right side keeps hopping the rail and out the drain. So far I have leveled, tried adjusting the ramp screws with angle, changed the post rubber, spun the ramp grommet. 35-40% of time results in a lost ball. Crazy

Exactly it.

I adjusted the ramp a little and put down a pair of Mylar strips on each side of the switch. It's more tolerable, like 15% up and out the outlane or hopping the rail now.

I find them too sticky which leads to easier catches and more forceful shooting. I dislike them and use nothing but real rubber on flippers but love the Titan line everywhere else.

I use red most of the time on everything. Though I think I have a normal rubber orange on one side and blue on the other with Tron currently.

I’m going to install service rails later today, is the playfield predrilled for the back side? If not anyone have a pic of the proper install points?

* edit found a good pic *
C3274E82-5928-4425-80FC-82E5869342BA (resized).png

I kind of did after the first