Is any one here having issues with there ghostbuster pin causing major air balls with server dimpling on playfield? I only own my pin for two days with less than 70 plays and I have deep dimpling all over my of? It seems almost every other hit with the flippers is causing the ball to fly across the filed. I also tried to get the pin leveled properly bit can't get it bubble in the middle of the leveler no matter what I do adjusting the feet? It seems that the back end of pin needs to go higher than the feed allow?

Yeah I was intending to but the crazzy part is the flippers are actually causing the ball to lift of the playfiled hitting the habbitrails, glass and opposite end of pinball walls. Is there a protective plastic that they sell for where the flippers make contact with the pinball? Thank you for your reply oldpinguy

Ok will do tonight thanks for the tip I hope it works seems to be doing lots of damage. You guys wouldn't know if stern would do or cover this under warnty. I got the pin 2 days ago and notice the side decal of cabinet that was shipped to me it had a cut like mark 2 inch vertically down like it was done by a razor by the looks of it at the end of the front of cabinet we're the sticker crease fold to meet the front end of cabinet coin door? Is this some thing they cover or is it just a flaw I have to work with

I'll check the leveler to see if it's put in correctly and see if If I raise the rubbers on the flippers up will help to stop the air balls it really bummed me out to see huge craters on the playfijed after only having played for two nights. I appreciate all the help every one

I would of hoped so by now there would of been. My ghostbuster premium said it was created September 19, 2016 the craters are noticeable when back light reflects on playfield I'll post a picture in a couple of hours so you guys could be the judge of it until than I won't be playing it much till I try all these great suggestions. If that don't work I'll have to see if there is a potictive air ball peice I can buy for gb premium

Hey thank you this is my fist new pinball i own but I started with two older EM pinballs about 4 years ago. I stared with arcade coin op fist, that's what led me into pinball witch I really enjoy more the last few years. I be sure to take pictures of the slice in my cabinet front end in next 2 hours it really surprised me to see that there now way I could of cut it cause there was that cushion foam protecting those corners and I recorded it when I open it with two phones to rewatch to be sure Do you know if that's some thing stern covers or is that a bite the bullet situation lol

Hey thanks guys for feed back that's what I though when I seen it it looks like the wood spit the overlay I call stern headquarters and spoke to Chas he said to send him some pic of the problem and would send replacement but it's only been a day so still waiting for his reply hope they don't put me off I'll try again in a couple of days

Thanks guys for the input I'll keep you inform on what the outcome will be