(Topic ID: 277423)
Linked Games
Avengers: Infinity Quest (Limited Edition)
Stern, 2020-
Avengers: Infinity Quest (Premium)
Stern, 2020
-
Avengers: Infinity Quest (pro)
Stern, 2020
Topic Gallery
You're currently viewing posts by Pinsider tsskinne.
Click here to go back to viewing the entire thread.
Quoted from heyitsjoebob:I'm really nervous about the glass being so tight. I've had to pull it a couple of times already for stuck balls, and it's sooooo tight. My JP's glass actually slid down by itself with the lockdown bar off. AIQ, I feel like I'm going to break it trying to slide it on or off.
Did Stern reduce the cabinet width by a quarter inch? Is my cabinet not square? What's the deal here?
My glass is also very tight to the cabinet but I honestly prefer it. I like not worrying about the glass sliding out on it's own when I remove the lockdown bar.
Quoted from WizardsCastle:Noticing some wear one both edges of the Ant-Man (mystery) scoop.
Anyone have any ideas for protection on this? Was thinking mylar, or reaching out to Cliff to get some small edge protectors made.
Also, anyone finding the cheap SDTM drains from the pops infuriating. I'm really enjoying the game except for this. Feels even cheap, and less nudgeable than the pop drop in TWD!
I think Cliffy already has them.
Premium owner, put it on location. I have had the 2 ball in subway problem happen twice in about 100 games so far. It can be easily fixed (if you are there obviously by going into coil test and firing the subway coil one time to separate the balls), but without being there eventually ball search should clear them. For the most part very happy with how it is playing.
Quoted from Jaybird815:My buddy just unboxed a premium and there is an issue with the flippers, they occasionally go dead and the lower end of playfield goes black. Any ideas on a fix? Already sent emails to distributor and Stern.
Love to know if you have a sollution, my avengers doesn't do this, but my JP does.
1 week later
Yeah I replaced my upper flipper titan with the factory rubber. Titans everywhere else holding up fine, just those direct shots I guess are brutal to this one.
2 months later
Quoted from tdiddy:Working on a CM ramp 3d printed piece if anyone is interested, I'm have more pictures later.
[quoted image]
Yep count me in as well
Quoted from tdiddy:Proto print....it will be cheap probably 15 bucks, I'll print it in red, with blue and gold highlights. Should just snap in no tape needed
[quoted image]
Nice, let me know how to order.
Promoted items from Pinside Marketplace and Pinside Shops!
Oakdale, MN
You're currently viewing posts by Pinsider tsskinne.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
