Here's the latest: Original problem was right slingshot inoperative. Cannot check that now because I am getting the "Check fuse F114 and F115" message, and the outhole kicker continues to fire over and over. The game will not go into Test Mode.
On the Power Driver board, I am getting 12vdc on TP1 (correct), no volts on TP3, and 16vdc on TP 8 (should be 18, maybe correct).
I have since reset all ribbon cables repeatedly, replaced Q2 7812 voltage regulator and capacitor C2. All solder joints tested for continuity. No change.
I swapped the 16-opto board with my SS. No change.
The next steps according to Pinwiki are to replace BR-1 and capacitors C6 and C7. Upon inspecting the board, I see that all four have been replaced. The bridges test good and the work looks OK. Diodes D1 and D2 test good. Also testing good was BR-5. And now I'm at the end of the checklist.
What did I miss? Any other questions or ideas? I'm trying to get this machine ready for Pinbrew, but I want it working and solid.
Again, thanks for your help guys,
Alan