(Topic ID: 190750)

No Fear magnet stuck on


By Anth

2 years ago



Topic Stats

  • 2 posts
  • 2 Pinsiders participating
  • Latest reply 2 years ago by Bongiorno
  • No one calls this topic a favorite

You

Linked Games

#1 2 years ago

I just pulled the playfield out of my No Fear for the first time to replace a few leg bolt plates and noticed that magnets one and two were disconnected. I'm not sure why magnet two was disconnected because it seems to be fine but when magnet one is connected it makes a loud buzzing noise. I'm assuming it is locked on. Any idea how to solve this?

3 weeks later
#2 2 years ago

I think the mag is bad ... See how many ohms is pushing with your meter.. Should be around 4.6'if it is 1. It's bad.. And if ump
Ug it in it will cook the resistor at u.66 or 68'check your Manuel ... Pinball life has then for sale at 24 bucks apiece.. But it is a bitch to get to them.. Got to take off everything n the playfield..ramps ect... Good luck..

Promoted items from the Pinside Marketplace
From: $ 27.00
Boards
KAHR.US Circuits
From: $ 9.99
Eproms
Matt's Basement Arcade
From: $ 18.00
Apparel - Men
Pinside Shop
From: $ 369.95
Boards
PinSound
From: $ 129.10
Cabinet - Sound/Speakers
PinWoofer

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside