If you are looking to help me please review my previous post found here:
https://pinside.com/pinball/forum/topic/bally-night-rider-early-ss-wont-boot#post-3716857
So I've installed a new Alltek MPU... followed the manual, checked the voltages and the board works great.
proper led's and all. The MPU seems to be fully operational. I set the switches like they were on the stock MPU
I set the Alltek for Night Rider which is all switches to the left set to -0- and the last one on the right to 1.
since it didn't boot I did turn all the switches back to -0- and tried to boot but nothing. will I have to reprogram
the board? Because I did play with all switches and attempted to reboot?
I get no sound on boot and no playable games.
When I press the red button on the door It goes into check mode... lights flash counters go up but then when its suppose
to run all the tests on the relays I get nothing...
where do I begin please...
I'm an SS novice with a DVM...
As always thanx in advance
-=Fred=-