No Good Gofers
Williams, 1997You're currently viewing posts by Pinsider jackd104.
Click here to go back to viewing the entire thread.
If I remember right…
Before you put on the gofer, rotate the wire forward down along the front of the plunger - tip of wire will be pointing down. It’s a spring so it will create resistance. Then put the gofer down over it.
The wire is a spring that causes the gofer to tilt forward so it catches and latches on when it pops up and will stay up (until it’s time to pop down again).
You're currently viewing posts by Pinsider jackd104.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/ngg-gofer-mech-wire-bending?tu=jackd104 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Fredericksburg, VA