Want to order an adapter but the website is down?
You're currently viewing posts by Pinsider JT-Pinball.
Click here to go back to viewing the entire thread.
Quoted from pincoder:Thank you! I'll drop it at the carriers today.
Fast Shipping!!!! Check. Thanks Craig!
Ok so I am working on a System 7 MPU. I have the board on the bench and not in the game. I also have the driver board disconnect as I am not sure if the status of it. I know power is good and I have changed the CPU to a new chip. With the pincoder adapter it will pass the first 5 test no problem. But once I replace ic17 board boots with a 0 then 0 stays on. When I push the diag button I get a 9. When I first started messing with it I got a 8 but I changed the 5101. Now it gives me a 9. Even without the driver board I think the MPU will fully boot?
Quoted from pincoder:While I've never tried it, it sounds like the Williams code does not boot successfully without a driver board attached.
How far can you get on the Pincoder tests with the driver board attached (please start from 01a-leds)
Solved! Just a word of note in the documents for the system 7 there is carry over from system 6 even though the location and actual chips are different.
You're currently viewing posts by Pinsider JT-Pinball.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/new-pincoder-adapter?tu=JT-Pinball and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.